潘洛斯672004宝马摩托车灯光安装教程

Panlos 672004 BMW Motorcycle Light Installation Tutorial

灯光材料如下

将箭头所指积木拆起

The lighting material is as follows

Remove the building blocks indicated by the arrow

打开A包,将车头灯安装如下

Turn on package A and install the headlights as follows

将插头导线穿到车身

打开B包,将灯条安装如下

Wear the plug wire to the car body

Open package B and install the light bar as follows

将较短的导线延箭头方向安装一侧灯条

Install the side lamp bar with the shorter wire extension arrow

将较长的导线穿到车尾

将灯条安装如下

Pass the longer wire to the rear

Install the light strip as follows

打开C包,拿出拆起的积木把灯条安装如下

将剩下的导线延箭头穿过积木

Open package C, take out the dismantled building blocks and

install the lamp strip as follows

Extend the remaining wire arrows through the blocks

车子翻转,安装另一侧灯条

Turn the car over and install the other side light strip

将积木拆起

Remove the blocks

拿出D包,把灯条安装如下

将导线穿过积木

Take out the package D and install the light strip as follows

Pass the wire through the building blocks

将最后一个灯条安装如下

如果插头导线太长,可以绕在积木上如图

Install the last light bar as follows

If the plug wire is too long, it can go around the block as shown

将所有插头插入连接板内

可以将连接板和电池放在图中位置(或放底部)

Insert all the plugs into the connecting board

Place the connection panel and the battery in the drawing

(or at the bottom)

积木还原

电池充电

Building blocks to restore

Battery charging

T3042宝马摩托车灯光安装教程

打开A包，将灯条安装如下

T3042 BMW Motorcycle Light Installation Tutorial

Open the package A, and install the light bar as follows

将插头导线延箭头方向穿过

打开B包，将灯条安装如下

Go through the plug wire extension arrow

Open package B and install the light bar as follows

将跟插头导线一个方向的灯条穿过积木安装如下

Install the light strip in the same direction as the plug

wire through the building block as follows

将剩下的一个灯条穿过积木安装如下

Install the remaining light strip through the blocks

as follows

拿出C包，将灯条安装如下

Take out the C package and install the light strip

as follows

将导线延箭头穿过积木

安装另一侧灯条

Run the wire extension arrow through the building blocks

Install the other side lamp strip

积木还原

拿出D包，将灯条安装如下

Building blocks to restore

Take out the package D and install the light strip as follows

将所有插头导线插入连接板中

Insert all of the plug wires into the connecting board