哈利波特密室灯光安装教程
Harry Potter Chamber of Secrets lighting installation tutorial
哈利波特密室灯光安装教程
Harry Potter Chamber of Secrets lighting installation tutorial
灯光如下
将积木分开出来
The lights are as follows
Separate the building blocks
拿出A包,将灯光组穿过积木如图
将第一个灯光组安装如下
Take out package a and pass the light group through the
building block, as shown in the figure
Install the Ding light group as follows:
将第二个灯光组安装在第二层
第三个灯光组安装在第三层
Install the second light group on the second floor
The third light group is installed on the third floor
最后一个安装在顶部位置如图
1
2
3
4
Most installed at the top, such as:
拿出B包,将积木安装如下
Take out package B and install the building blocks as
shown in Fig
将剩下的积木穿到第二层安装如下
Thread the remaining building blocks to the second floor
for installation, such as:
将导线延箭头方向穿过安装如图
拿出C包,将积木安装如下
Thread the wire in the direction of the arrow, as shown
in the figure
Take out package C and install the building blocks as shown
in Fig
剩下的导线穿过积木如图将灯粒安装如下
拿出D包,将2个灯光组安装如下
The wire passes through the building block as shown in the figure
and the lamp particles are installed as shown in the figure
Take out package D and install 2 light groups as shown in
将多余导线藏于积木内
拿出E包,首先将灯条穿过积木
Hide the excess wires in the building blocks
Take out package e, first pass the light bar through the building
block
将灯条安装在窗上如图
最后将所有插口插入连接板内
Install the light strip on the window, as shown in the figure
Finally, insert all sockets into the connection board
可以将其放在如图位置
It can be placed at the position shown in the figure